neroal.blogg.se

This button can be used \rin an emergency or for normal shut down after operations.\r\rPRESSURE LED\r\r The amber LED is on to indicate operation in the pressure mode.\r\rRPM LED\r\r The red LED is on to indicate operation in the RPM mode.\r\rMODE Button\r\r Selects the pressure or RPM mode of operation.\r\rTHROTTLE READY LED\r\r This LED will be on when the required interlock conditions are met and the \rgovernor is ready to begin operations.\r\rPRESET Button\r\r Press to change/select a pre-programmed value for pressure or RPM setting.\r\rINC / DEC Buttons\r\r During operations the buttons increase and decrease pressure or RPM setting.\r\rRPM Display\r\r Shows the engine RPM during normal operations.\r\rCHECK ENGINE / STOP ENGINE LED\r\r Repeats the engine warnings from the cab.)>ġ500 0 obj>/Matrix/Length 1092/Filter/FlateDecode> \(Refer to Figure 1.\)\r\rPUMP DISCHARGE Display\r\r Shows the pump discharge pressure during normal operations.\r\rPUMP INTAKE Display\r\r Shows the pump intake pressure during normal operations and codes during \rprogramming.\r\rIDLE Button\r\r When pressed immediately sets the engine RPM to idle. CHECK ENGINE / STOP ENGINE LED Repeats the engine warnings from the cab.)/Contents(GENERAL DESCRIPTON\r\rControls and Indicators \r\r All Fire Commander II controls and indicators are located on the front of the control \rmodule. RPM Display Shows the engine RPM during normal operations. INC / DEC Buttons During operations the buttons increase and decrease pressure or RPM setting. PRESET Button Press to change/select a pre-programmed value for pressure or RPM setting. THROTTLE READY LED This LED will be on when the required interlock conditions are met and the governor is ready to begin operations. MODE Button Selects the pressure or RPM mode of operation. RPM LED The red LED is on to indicate operation in the RPM mode. PRESSURE LED The amber LED is on to indicate operation in the pressure mode. This button can be used in an emergency or for normal shut down after operations.

IDLE Button When pressed immediately sets the engine RPM to idle. PUMP INTAKE Display Shows the pump intake pressure during normal operations and codes during programming. \(Refer to Figure 1.\) PUMP DISCHARGE Display Shows the pump discharge pressure during normal operations.

Q 1 0 0 1 0 0 cm 1 1 1 rg 0 0 0 RG 0 w BT 0 0 0 rg /Times 14 Tf 1 0 0 1 513.6259 416.6516 Tm (13) Tj ET Qġ498 0 obj/M(D:20090910081119-05'00')/AP/Rect/NM(CONKZWQPKHELJIFQ)/RC( GENERAL DESCRIPTON Controls and Indicators All Fire Commander II controls and indicators are located on the front of the control module. 12\r Pump Discharge Pressure is High at Engine Idle.

12 Pump Discharge Pressure is High at Engine Idle.